Purus Line Living Plus 600mm Linear Drain for Vinyl Floors with Stainless Steel Chess Grate - Choice of Waste Gully Outlet with NOOD Water Trap

Purus 630mm Living Plus linear channel drain for wet rooms with vinyl flooring.

Designed for use with concrete / screed floors and timber floors. Also available in a kit form with the Maxxus Linear floor former (See Product Code: 6821985-9/V.

Key benefits:

• 630mm length linear channel drain
• PP - bodied unit
• Removable sprung NOOD water trap
• The NOOD no-odour water trap which will not allow any foul air to escape even if the gully dries out
• Removable stainless steel channel grate - Chess design
• The grate when installed will be flush with the vinyl flooring, due to the new clamping ring technology
• For vinyl sheet floor finishes, that should be secured in the gully clamping frame
• Includes 2 x support legs for screed floors
• Includes joist installation kit for timber floors

Technical details:

• Overall length (mm): 630
• Overall width (mm): 130
• Grate length (mm): 588
• Grate width (mm): 88
• Depth of channel (mm): 21, (plus depth of gully outlet - see below)
• Grate loading: Class K 3 (300 kg)

Waste options:

• Choice of three gully outlets each with a push-fit ABS pipe reducer 2” to 1½” (50mm to 40mm):
• - Low Side Outlet with 30-36 ltr/min flow rate - Waste depth / Overall (mm): 52 / 73
• - Side Outlet with 60-72 ltr/min flow rate - Waste depth / Overall (mm): 105 / 126
• - End Parallel (Side Side) Outlet with 60-72 ltr/min flow rate - Waste depth / Overall (mm): 105 / 126
• Please select above as desired

Installation Guidance:

• The minimum gradient should be 1:150 to ensure the flow of water to the floor trap and no more than 1:50 to reduce the risk of slipping
• A nominal 2% falls is usually used
• Do not install the product on a raised platform. It is designed only to be installed level with the surrounding floor

Concrete / Screed Floor Installation:

• Build falls to the gully with screed so water can run into it
• Supplied with 2 x plastic concrete supports, for setting the gulley height and level prior to casting the concrete screed
• The Concrete supports have a min. height of 88mm and a max height of 195mm with a distance case at 50mm
• Refer to the PDF download installation instructions for more information

Timber Floor Installation:

• Check the level of the joists and floorboards prior to installation of the tray and marine ply. They must be flat and level
• The joists and floor must be made sound and secure according to BS 5268 and for BS 6178 if using joist hangers
• Use appropriate marine ply boards in accordance with BS 8203:2017 for vinyl flooring
• Noggins or structural supports need to be added to the joists. These are required to add extra support for the tray and the channel around its perimeter
• Refer to the PDF download installation instructions for more information